# Heat Pump Installation Estelle LA | Electric Heat Swaps

> Heat pump installation for Estelle homes moving off an air conditioner and electric furnace, with the outdoor spot, backup heat and permit planned. Ask us.

URL: https://sweetolivenolaheatpumps.com/service-areas/estelle/

Heating an Estelle house with an electric furnace and cooling it with an air conditioner that is wearing out? We plan the move to one heat pump around your heating load, your yard's low spots and the Jefferson Parish permit, then set it all out in one written estimate.

Heat pump on a low steel stand against the back wall of an Estelle ranch house.

## What brings Estelle homeowners to us

### The air conditioner is failing

The outdoor unit is old and the electric furnace beside the coil still works. Now is the time to ask whether one heat pump should do both jobs.

### Electric heat on every cold morning

The furnace heats with resistance strips alone. You'd like a system that leans on them only when it has to.

### Water in the back corner

After heavy rain, the outdoor unit's corner of the yard holds water for hours. The new unit needs a better spot or a stand.

### A bigger house, one system

Four bedrooms on one system, with the far rooms behind. The ducts and the return get tested before the size is chosen.

Last updated: November 18, 2026

The air conditioner is wearing out, and every cold morning the electric furnace in the closet heats the house on its resistance strips alone. You’re wondering whether one heat pump should handle both seasons, and where its outdoor unit should go in a yard that holds water.

[Sweet Olive](https://sweetolivenolaheatpumps.com/) installs ducted air-source heat pumps and replaces older systems in Estelle and across [our service area](https://sweetolivenolaheatpumps.com/service-areas/). Moving from an air conditioner and electric furnace to a heat pump usually keeps the ducts and changes the equipment at both ends. In Estelle the permit goes to Jefferson Parish. On the first visit we size the system from your rooms, check the furnace circuit and walk the whole yard. Your written estimate names the equipment, the backup heat, the outdoor spot and the parish permit steps.

If the system still has life in it, start with [maintenance](https://sweetolivenolaheatpumps.com/heat-pump-maintenance/) or a repair. The [conversion page](https://sweetolivenolaheatpumps.com/heat-pump-conversion/) explains the switch in full, and the [central AC comparison](https://sweetolivenolaheatpumps.com/guide/heat-pump-vs-central-ac/) sets out the difference.

## What an AC-to-heat-pump swap in Estelle looks like

A tired air conditioner, an electric furnace doing all the heating and a back corner that held rainwater: one Estelle conversion, decided around the yard.

Before

After

- **Location**: Estelle, off Barataria Boulevard
- **Home**: Single-story slab house, about 1,800 sq ft, four bedrooms
- **System**: Nominal 3-ton two-stage heat pump with an 8 kW heat strip
- **Replaced**: Central AC and electric furnace
- **Outdoor unit**: Moved to a 24-inch stand by the back wall
- **Access**: 36-inch side gate, utility-closet air handler
- **Project price**: $8,350
- **Duration**: 2 working days

The setting

### Electric heat and a wet corner

The house was a single-story slab home off Barataria Boulevard in Estelle, about 1,800 square feet with four bedrooms. A central air conditioner cooled it and an electric furnace in the utility closet heated it on resistance strips alone. The air conditioner was failing. Its outdoor unit sat on a pad in the back corner of the yard, where water stood for hours after a heavy rain.

The decision

### A heat pump that heats, and a drier spot

Replacing the air conditioner like for like meant keeping the resistance strips as the only heat. The heat pump we chose moved heat instead of making it, and kept an 8 kW strip for the coldest mornings. The load calculation supported a nominal three-ton, two-stage system. We moved the outdoor unit to a 24-inch stand against the back wall, the higher part of the yard, once the parcel's floodplain requirement was checked.

The lot in plan: the route through the side gate, the clearance kept around the new outdoor spot and the utility closet inside.

The work

### Two days through a 36-inch gate

On day one we recovered the refrigerant, took the old units out through the side gate and set the new air handler in the closet on the existing duct connections, which tested sound. The existing furnace circuit stayed after we checked its breaker and wire against the new nameplate. On day two we bolted the stand to its footings, ran a new 15-foot line set, brazed under nitrogen, pressure-tested and evacuated, and filled the old pad's spot with soil.

The handover

### Defrost and backup heat confirmed

We checked the charge, airflow and static pressure, tested the drain, then confirmed the defrost cycle and the heat strip and set the thermostat so the strip ran only when the heat pump needed help. The readings stayed with the owner, and the Jefferson Parish inspection followed. The aim was a house that leaned on the heat pump through most of the winter, with the strip saved for the cold mornings, and an outdoor unit kept out of standing water.

## From resistance heat to a heat pump

An electric furnace makes heat; a heat pump moves it, and that changes how the winter feels on the bill.

54.3°F

Average daily temperature in January at the New Orleans airport, from National Weather Service climate normals

Most winter hours here are mild, which is when a heat pump does its best work and the backup strip can stay off.

### What changes and what stays

The outdoor air conditioner and the indoor furnace cabinet both come out, replaced by a heat pump and its matched air handler. Sound ducts stay, after we test them for leakage and static pressure. The furnace’s circuit can often carry the new air handler’s heat strip once we check its breaker and wire against the nameplate.

An air handler in an interior closet, where an electric furnace often stands today.

A thermostat set so the heat strip runs only when the heat pump needs help.

### Sizing the strip, not the biggest one

A heat strip covers defrost and the coldest mornings. We size it from your heating load in the room-by-room calculation (ACCA Manual J), not at the largest strip the cabinet accepts, and set the thermostat so it stays off on mild days. The [cold-weather guide](https://sweetolivenolaheatpumps.com/guide/heat-pump-cold-weather/) explains how a heat pump behaves in a cold snap.

### Four bedrooms on one system

In a larger single-story house, the far bedrooms sit at the end of long duct runs. We check those runs and the return path from each room, and long or crushed runs go into a [ductwork repair](https://sweetolivenolaheatpumps.com/heat-pump-ductwork-repair/) line instead of a bigger unit.

## Yards at the edge of the wetlands

Estelle reaches south toward the Barataria Preserve, and heavy rain finds the low corners of its yards.

### Next to the preserve

The Barataria Preserve, part of Jean Lafitte National Historical Park and Preserve, covers about 26,000 acres of bayous, swamps, marshes and forest just outside Marrero, along the southern edge of Estelle. Yards on this side of the West Bank can hold water for hours after a summer storm, and the outdoor unit is often in the lowest corner.

### Choosing the spot and the height

Heating and cooling equipment isn’t built to sit in water. We look at where it stands after rain, then check the parcel’s floodplain requirement with Jefferson Parish before keeping the old pad, pouring a new one or setting a stand. Manufacturers set clearances around the coil and the service panel, and a short line set to a higher spot is often worth it. The [placement guide](https://sweetolivenolaheatpumps.com/guide/heat-pump-outdoor-unit-placement/) shows the options.

An outdoor unit set on a stand beside the steps, above the ground around it.

## Permits and the Marrero mailing address

Estelle is unincorporated Jefferson Parish, and its addresses don't always say so.

### One parish office

Installing or replacing heating and cooling equipment in Estelle is filed with the Jefferson Parish Building Regulatory Division before the work, and inspected after. Some Estelle addresses carry a Marrero mailing city; [Marrero](https://sweetolivenolaheatpumps.com/service-areas/marrero/) and [Woodmere](https://sweetolivenolaheatpumps.com/service-areas/woodmere/) go to the same parish office, so the filing is the same. Your estimate states who obtains the permit, and the [permit guide](https://sweetolivenolaheatpumps.com/guide/heat-pump-permits/) compares the offices.

The electric account

We confirm which utility serves your account at the visit. Rebate programs depend on it, so we never count one in your budget until it is confirmed.

## What an Estelle swap costs

Our range is the same here; the yard, the ducts and the circuit decide where you land.

**Sweet Olive's typical range for a residential ducted heat pump replacement is $4,250 to $11,750.** We set your price after the site visit and write it into your estimate line by line, with any stand, duct work and the Jefferson Parish permit steps shown separately.

What moves an Estelle price

- **Equipment and strip.** Capacity and stages from the load calculation, and the heat strip size.
- **The outdoor spot.** Keeping the pad, a new pad, or a stand on a higher part of the yard.
- **The ducts.** Sealing joints or repairing long runs to the far bedrooms.
- **The circuit.** Reusing the furnace circuit after a check, or adding one.
- **Controls.** A thermostat that runs the strip only when needed.

The [cost guide](https://sweetolivenolaheatpumps.com/guide/heat-pump-cost/) breaks a price into its parts.

## How an Estelle job usually runs

Five steps, with the outdoor spot and the backup heat settled before the equipment is ordered.

1. Send the address Tell us what heats and cools the house now, and send a photo of the outdoor unit's corner after rain if you have one.
2. We visit and measure Rooms for the load calculation, the air handler closet and its circuit, the ducts, the panel and the whole yard.
3. Your written estimate Equipment, the heat strip size, any stand or pad, the parish permit steps and exclusions, priced line by line.
4. Filing, then the work days The permit is handled as your estimate states, then the work days are booked with the route to the closet protected.
5. Startup and inspection Charge, airflow, defrost and backup heat confirmed, the thermostat set, the readings left with you, then the parish inspection.

## Around Estelle

Permits: Jefferson Parish. Electric service: Entergy Louisiana, confirmed for your address.

Neighborhoods

- Along Barataria Boulevard
- Near the Barataria Preserve
- Streets bordering Marrero
- Toward Woodmere

Landmarks

- Barataria Preserve
- Jean Lafitte National Historical Park and Preserve

Main routes

- Barataria Boulevard
- Lapalco Boulevard
- Louisiana Highway 45

Estelle and the communities around it that we serve. [Open the area in Google Maps](https://www.google.com/maps/search/?api=1&query=Estelle%2C%20Louisiana)

## Questions from Estelle

### Does a heat pump heat an Estelle house for less than an electric furnace?

In most winter weather a heat pump moves heat from outdoors instead of making it from resistance strips, so it uses less electricity for the same warmth. How much less depends on your rates, your settings and how cold the winter turns, so we don't promise a figure. Our operating cost guide shows how to estimate it for your house.

### What does swapping an AC and electric furnace for a heat pump cost in Estelle?

Our typical range for a residential ducted heat pump replacement is $4,250 to $11,750. A swap that reuses sound ducts and the existing furnace circuit sits lower; a raised stand, duct repairs or a new circuit move it up. We set your price after the visit and write each item into the estimate.

### Can the new heat pump use the heat strips from my old electric furnace?

Not the old cabinet itself. The new heat pump comes with a matched air handler, and its heat strip is sized from your heating load. The old furnace's circuit can often stay, once we check its breaker and wire against the new nameplate.

### Does living near the Barataria Preserve change where the outdoor unit can go?

The preserve itself doesn't set the rule for your yard. The parish's floodplain requirement for your parcel and where water actually stands after rain decide the spot and the height. We check both before choosing between the old pad, a new pad and a raised stand.

### Will the heat strip run all winter once the heat pump is in?

It shouldn't. Set up correctly, the thermostat runs the strip during defrost and on the coldest mornings when the heat pump needs help. A miswired or badly set control can bring it on far too often, so we confirm the heat strip and defrost at startup and leave the settings with you.
