# Heat Pump Installation Chalmette LA | Raised & Slab Homes

> Heat pump installation and replacement for Chalmette homes, raised or on slab, filed with St. Bernard Parish and priced in one written estimate. Ask for yours.

URL: https://sweetolivenolaheatpumps.com/service-areas/chalmette/

A system that switches on and off every few minutes, or an outdoor unit perched on a platform that has seen better days? In Chalmette we plan the replacement around how high your house sits, what holds the equipment and the St. Bernard Parish filing, then price it in one written estimate.

Heat pump on a galvanized stand beside the stairs of a raised Chalmette home.

## What brings Chalmette homeowners to us

### Short cycles, warm rooms

The system starts and stops every few minutes and one room never cools. Oversizing, a refrigerant problem and a duct fault can all do it.

### Equipment up high

The house was raised and the outdoor unit went up with it, on a platform or stand. What holds it matters as much as the unit.

### The rebuild system is aging

The heat pump that went in when the house was rebuilt is wearing out, and you want the replacement sized to the house as it is now.

### A slab house near the levee side

The outdoor unit sits on a pad at grade. Where water stands after a storm decides whether it stays or goes up.

Last updated: November 18, 2026

The heat pump kicks on, runs a few minutes and stops, over and over, and the den still feels warm. Out back, the outdoor unit sits up at floor level on a platform whose boards have started to give. Is it time to replace the system, and what should hold the new one?

[Sweet Olive](https://sweetolivenolaheatpumps.com/) installs and replaces ducted air-source heat pumps in homes across Chalmette and the rest of [our service area](https://sweetolivenolaheatpumps.com/service-areas/). Chalmette is the seat of St. Bernard Parish, and the parish handles the permit. On the first visit we test the system before blaming it, check the attic ducts and the panel, and look hard at whatever holds the outdoor unit. Your written estimate lists the equipment, any stand or platform work and the parish permit steps.

If the system might be saved, start with [repair](https://sweetolivenolaheatpumps.com/heat-pump-repair/). If it is done, the [replacement page](https://sweetolivenolaheatpumps.com/heat-pump-replacement/) covers the decision, and the [warning signs guide](https://sweetolivenolaheatpumps.com/guide/heat-pump-warning-signs/) helps you read the symptoms.

## What a Chalmette replacement on a raised house looks like

An outdoor unit raised on a softening wood platform, a failing system and a St. Bernard Parish filing.

Before

After

- **Location**: Buccaneer Villa North, Chalmette
- **Home**: Single-story raised home, about 1,450 sq ft, two bedrooms and a den
- **System**: Nominal 2.5-ton single-stage heat pump
- **Outdoor unit**: Moved from a wood platform to a galvanized steel stand at the same height
- **Air handler**: Attic, over the hall
- **Drain**: Rerouted to the exterior with a new trap
- **Line set**: 28 feet, new
- **Project price**: $8,150
- **Duration**: 2 working days

The setting

### Equipment up high, platform giving way

The house was a single-story raised home in Buccaneer Villa North, about 1,450 square feet with two bedrooms and a den. The heat pump that went in when the house was raised was short-cycling and leaving the den warm. Its outdoor unit sat up off the ground on a wood platform beside the back stairs, and the platform's boards had started to soften.

The decision

### Kept high, with a new stand under it

Bringing the outdoor unit down to a pad at grade was the alternative, with a shorter, easier service reach. The owners wanted it kept up, so we replaced the wood platform with a galvanized steel stand at the same height. The load calculation supported a nominal two-and-a-half-ton system, and the attic ducts tested sound apart from a loose collar at the den branch.

How the two work days divided: removal and the new stand on day one, connections and checks on day two.

The work

### Stand, unit, then the attic

On day one we recovered the refrigerant, lowered the old outdoor unit, removed the platform, and set and anchored the steel stand with a new disconnect at its height. The new unit went on top. In the attic, the new air handler went over the hall on a fresh secondary pan and float switch, and the drain was rerouted to the outside with a new trap. On day two we ran a new 28-foot line set, brazed under nitrogen and evacuated to a micron reading.

The handover

### A cooler den, a sturdier stand

We resealed the den collar with mastic, set the thermostat, tested the float switch and recorded airflow and charge. St. Bernard Parish inspected after the work. The aim was steady cooling in the den and outdoor equipment that sat on something built for it.

## Houses rebuilt, raised or both

Chalmette's houses sit at different heights, and the equipment follows the house.

### When the house went up

Hurricane Katrina flooded most of Chalmette in 2005, and many houses were rebuilt in the years after, some raised on piers or higher foundations. Where a house was raised, the outdoor unit generally goes up with it, onto a wood platform or a steel stand near the back steps, and the air handler may sit in the attic or a closet. We size a replacement from the house as it stands now, with a room-by-room load calculation.

### When it stayed on the slab

Slab houses keep the outdoor unit on a pad at grade. We look at where water stands after a heavy storm and check the parcel’s requirements before deciding whether the pad stays or the unit goes onto a stand. The [placement guide](https://sweetolivenolaheatpumps.com/guide/heat-pump-outdoor-unit-placement/) covers clearances too.

A covered porch raised above the yard, reached by a short flight of steps.

## Short cycling: what it can mean

A system that keeps stopping isn't always a system that needs replacing.

Causes we check before quoting

- **Oversized equipment.** It hits the setpoint fast and stops before drying the air.
- **Refrigerant charge.** Low charge can trip safety controls.
- **A failing part.** A capacitor, contactor or sensor acting up.
- **Thermostat placement.** A control in sun or in a supply draft misreads the room.
- **Ducts.** A loose run starving one room while the hall satisfies the thermostat.

A wall thermostat on an inside hall wall, away from windows and supply registers.

### Repair, or replace with the right size

If a part is the cause and the system is otherwise sound, a [repair](https://sweetolivenolaheatpumps.com/heat-pump-repair/) may be the better spend. If the equipment was oversized from the start or is near the end, replacement lets us size it correctly. The [components guide](https://sweetolivenolaheatpumps.com/guide/heat-pump-components/) explains the parts involved, and the [sizing guide](https://sweetolivenolaheatpumps.com/guide/heat-pump-sizing/) shows the load calculation.

## Permit and power in St. Bernard Parish

A separate parish, with its own forms.

St. Bernard Parish keeps its own mechanical permit application and safety-permit process, so Chalmette heating and cooling work is filed there, not with New Orleans. The parish line with the city runs past Arabi, a few minutes upriver. Your estimate states who obtains the permit, and the [permit guide](https://sweetolivenolaheatpumps.com/guide/heat-pump-permits/) covers the steps.

Chalmette homes are generally on Entergy Louisiana accounts. The Energy Smart rebate is for Entergy New Orleans residential accounts, so we confirm your account before counting any incentive.

## What a Chalmette replacement costs

Our range holds across the parish line; your house sets the figure.

**Sweet Olive's typical range for a residential ducted heat pump replacement is $4,250 to $11,750.** We set your price after the site visit and write it into your estimate line by line, with any stand or platform work and the St. Bernard Parish permit steps shown separately.

What moves a Chalmette price

- **What holds the outdoor unit.** Reusing a sound stand, or a new steel stand or pad.
- **Height and distance.** A longer line set from a raised unit to an attic air handler.
- **Attic access.** Pull-down stair, platform, and a new secondary pan and float switch.
- **Equipment.** Capacity from the load calculation, single-stage or two-stage.
- **Ducts and drain.** Resealing loose collars, rerouting a drain line.

An indoor air handler with its return connection and drain line in view.

## How a Chalmette job usually runs

From the address to the St. Bernard Parish inspection.

1. Send the address The address confirms the parish. Tell us how the system behaves and send a photo of the outdoor unit and what holds it.
2. We visit Rooms, the attic or closet air handler, the ducts, the panel, and the platform, stand or pad outside.
3. Written estimate Equipment, any stand or platform work, duct repairs, the St. Bernard Parish permit steps and exclusions, priced line by line.
4. Permit and work days The permit is handled as your estimate states, then the work days, with the outdoor support done before the new unit goes up.
5. Startup and inspection Charge, airflow, drain and float switch, thermostat and the readings left with you, then the parish inspection.

## Around Chalmette

Permits: St. Bernard Parish. Electric service: Entergy Louisiana, confirmed for your address.

Neighborhoods

- Buccaneer Villa North
- Chalmette Vista
- Lexington Place

Landmarks

- Chalmette Battlefield
- Chalmette National Cemetery
- Frederick J. Sigur Civic Center

Main routes

- St. Bernard Highway
- Paris Road
- Jean Lafitte Parkway

Chalmette and the communities around it that we serve. [Open the area in Google Maps](https://www.google.com/maps/search/?api=1&query=Chalmette%2C%20Louisiana)

## Questions from Chalmette

### Do I file a heat pump permit with St. Bernard Parish or with New Orleans?

With St. Bernard Parish. Chalmette is the parish seat, and the parish keeps its own mechanical permit application and safety-permit process. Addresses across the parish line, upriver past Arabi, file with the City of New Orleans instead. Your estimate states who obtains the permit and when the inspection happens.

### Does a raised house cost more for a heat pump in Chalmette?

It can, though our typical range for a residential ducted heat pump replacement stays $4,250 to $11,750. A raised house can add a new stand or platform, a longer line set or harder attic access. We set your figure after the visit and show those items as their own lines.

### Should the outdoor unit stay up high or come down to the ground?

Heating and cooling equipment isn't built to sit in floodwater, so on a low lot height protects it, and the parcel's requirements may set a minimum. A unit at grade is easier to reach for service. We look at where water stands and check the parcel before recommending either.

### Why does my heat pump turn on and off every few minutes?

Short cycling has several causes. Equipment too big for the house reaches the setpoint and stops, a low refrigerant charge or a failing part can trip it, and a thermostat in a poor spot can misread the room. We test before recommending a repair or a replacement.

### Can a wood platform carry a new outdoor unit?

Only if it is sound, level and built for the weight. Wood exposed to the weather softens over the years, and a unit that tilts strains its line set and drain. We check it at the visit; if it fails, a galvanized steel stand at the same height goes on the estimate.
