# Heat Pump Inspection New Orleans | Written Findings

> A heat pump inspection for a New Orleans home: equipment, ducts, drain and controls reviewed and measured, with written findings and next steps. Ask for one.

URL: https://sweetolivenolaheatpumps.com/heat-pump-inspection/

Just bought a house with a heat pump nobody can tell you about? Wondering whether yours will make it through another summer, or whether it came through a storm unharmed? We review and measure the system, then write down what we found and what it does and doesn't tell you.

Technician inspecting the drain pan of an attic air handler in a Carrollton home.

- Inspections of ducted heat pumps in homes
- Both modes run and measured
- Written findings and next steps
- Priced as one visit, before we book it

Last updated: November 18, 2026

Maybe the heat pump came with a house you just bought, and nobody can tell you when it was last serviced. Maybe it has run for years and you want to know whether to budget for a replacement. Or a storm sent water across the yard and you’re not sure the system should be switched back on. None of those is a repair request yet. You want to know where the system stands.

[Sweet Olive](https://sweetolivenolaheatpumps.com/) inspects ducted heat pumps in homes [across New Orleans](https://sweetolivenolaheatpumps.com/service-areas/). We read both nameplates, look at the equipment, the drain and the duct runs we can reach, then run the system in cooling and in heat while we measure it. You get written findings, in order of importance, that separate what we measured from what we can’t yet know.

An inspection isn’t a [maintenance visit](https://sweetolivenolaheatpumps.com/heat-pump-maintenance/): we don’t clean or service the system unless you ask. It isn’t a [repair](https://sweetolivenolaheatpumps.com/heat-pump-repair/) call either, though it often shows whether one is needed.

## Inside a Carrollton heat pump inspection

A newly bought house, a system with no paperwork and a musty hall: what the inspection checked before anyone talked about replacing it.

Before

Detail

- **Location**: Carrollton, New Orleans
- **Home**: Raised single-story home, about 1,800 sq ft, three bedrooms, newly bought
- **System**: Nominal 3.5-ton heat pump, attic air handler, no service records
- **Reviewed**: Outdoor unit, attic air handler, ducts, drain and controls
- **Run tests**: Cooling and heat mode, backup heat
- **Written next steps**: Drain repair, line insulation, return review
- **Project price**: $195
- **Duration**: One visit, about 2.5 hours

The question

### A new house and an unknown system

The home was a raised, single-story house in Carrollton, about 1,800 square feet, bought in the spring. The heat pump came with the house and no service records. Nothing had failed, but the hall smelled musty after rain and the owner wanted to know where the system stood before the first full summer.

The look

### From the nameplate to the attic

We read both nameplates for the capacity, refrigerant and manufacture date, then walked the outdoor unit, the line set and the attic. The air handler sat over a secondary pan holding water, with rust on its floor and no float switch. Along the outside wall, about eight feet of suction-line insulation was cracked and falling away.

- **Each room**: windows, sun and ceiling height for the load calculation
- **Attic opening**: headroom and joists
- **Return location**: where a central return can draw air
- **Electrical panel**: rating, open spaces and existing load
- **Outdoor spot**: footing and drainage
- **Thermostat**: on an inside wall

The stops the inspection covered on a three-bedroom plan: rooms, attic opening, return, panel, outdoor unit and thermostat.

The run

### Both modes, measured

We ran the system in cooling, then heat, with the backup strip called on. We measured the temperature drop across the coil, the amp draw at each motor and the static pressure across the air handler. The static pressure sat above the blower's rated range, and the single return grille in the hall was small for the system's airflow.

The findings

### Three next steps, no new unit

The written findings listed three items in order: fix the primary drain and add a float switch to the secondary pan, replace the cracked insulation, and review the return before summer. Nothing pointed to replacing the system then. Each item went on the findings as its own repair to price, so the owner chose what came first.

## When an inspection is worth booking

An inspection is for a decision you haven't made yet. These are the most common ones.

- **Buying a house.** You want to know what the system is, how old it is and what the first year may cost.
- **A system with no records.** Nobody knows when it was last serviced or what has been replaced.
- **After a storm or high water.** Water reached the outdoor unit, the air handler or the wiring.
- **Before a big decision.** You’re weighing a repair, a replacement or a duct change and want facts first.
- **A house that never feels right.** Rooms run warm or damp, or the system runs much longer than it used to, with no clear fault.

Duct runs in an attic, where an inspection looks for crushed runs and loose connections.

### When another visit fits better

If the system has stopped cooling or heating, or water is coming through a ceiling, book a [repair](https://sweetolivenolaheatpumps.com/heat-pump-repair/), because the visit starts with that fault. If you know the system is sound and just want it serviced, a maintenance visit is the right choice.

## What we look at, and what we measure

An inspection has two halves: a careful look with the system off, then measurements with it running.

An outdoor unit on its pad: the coil, the cabinet and the line set insulation are all read on the inspection.

### With the system off

We read both nameplates for capacity, refrigerant and the manufacture date, then look at the outdoor coil, the pad or stand, the clearances and the insulation on the line set. Inside, we look at the air handler cabinet, the coil we can see, the blower, the heat strip, the drain trap, the secondary pan and the float switch. In the attic or crawlspace we follow the duct runs we can reach and check their connections. Our [components guide](https://sweetolivenolaheatpumps.com/guide/heat-pump-components/) explains what each of these parts does.

| Measurement | What it shows |
| --- | --- |
| Temperature drop across the coil in cooling | Whether the coil is removing heat as expected for the conditions |
| Temperature rise in heat mode | Whether the heat pump and the heat strip are adding heat |
| Amp draw at each motor and the heat strip | Electrical wear or strain, compared with the nameplate |
| Static pressure across the air handler | Whether the ducts and filter let the blower move its air |
| Defrost and changeover | Whether the reversing valve switches cleanly |

The measurements an inspection takes with the system running, and what each one shows.

If a startup record exists, today's readings are set beside it to show what has changed.

## Reading the results honestly

Measurements narrow things down. They rarely prove a single cause on their own.

### What the readings can show

A coil that cools well, motors that draw close to their ratings and static pressure inside the blower’s range describe a system working as designed on the day. A full secondary pan, a missing float switch, burned wire or cracked insulation are plain findings with plain fixes. These go at the top of your findings.

### What they can only suggest

High static pressure can come from a small return, a clogged filter, a dirty coil or crushed ducts. A weak temperature drop can mean low charge, low airflow or simply a mild, dry day. Where a reading points to more than one cause, we say so, and we name the test that would settle it, such as a duct leakage test or a load calculation. The [ductwork guide](https://sweetolivenolaheatpumps.com/guide/heat-pump-ductwork/) covers duct testing.

Thermostat wiring and settings are checked as part of the heat run.

### Efficiency and running cost

An inspection can show whether the system is running close to how it should, but not what it costs you each month. The bill depends on the weather, your rate, the house and how the thermostat runs the backup heat. Our [operating cost guide](https://sweetolivenolaheatpumps.com/guide/heat-pump-operating-cost/) explains how SEER2, HSPF2 and the heat strip show up on a bill.

## What your findings may lead to

Each finding comes with a suggested next step. Most are small; none is required.

| Finding | Suggested next step |
| --- | --- |
| Full or rusted secondary pan, no float switch | A drain repair and a float switch, priced as a [repair](https://sweetolivenolaheatpumps.com/heat-pump-repair/) |
| Dirty coils, slow drain, worn filter setup | A [maintenance visit](https://sweetolivenolaheatpumps.com/heat-pump-maintenance/) |
| High static pressure, rooms short of air | A duct review and [ductwork repair](https://sweetolivenolaheatpumps.com/heat-pump-ductwork-repair/) |
| A failing major component on a worn system | A [replacement](https://sweetolivenolaheatpumps.com/heat-pump-replacement/) priced beside the repair |
| Nothing significant | Nothing now; keep the findings for the next visit |

Common inspection findings and the next step we suggest for each.

### Repair or replace, if it comes to that

An old system that inspects well is not a reason to replace it. A newer one with a failing compressor may be. When the findings raise that question, our [repair or replace guide](https://sweetolivenolaheatpumps.com/guide/heat-pump-repair-or-replace/) sets out what to weigh, and we price both options if you ask.

## What an inspection costs

An inspection is one visit, priced before we book it.

### How we price it

We price an inspection as a single visit and tell you the price when we book it. It follows how many systems the house has, where the air handlers sit, and whether you want extra testing such as a duct leakage test. Any repair the findings suggest is priced on its own, and only if you want it.

**Sweet Olive's typical range for a residential heat pump maintenance visit is $70 to $200.** If you want the system cleaned and serviced at the same visit, that is a maintenance visit, and we list its checks before we book it.

## What an inspection includes

We confirm the checks for your system when we book the visit. A typical inspection covers these.

- Both nameplates read for capacity, refrigerant, electrical ratings and manufacture date
- The outdoor unit, its pad or stand, clearances and the line set insulation
- The air handler, coil, blower, heat strip and the space around them
- Condensate drain, trap, secondary pan and float switch
- Duct connections and runs we can reach at the air handler and in the attic or crawlspace
- A cooling run with the temperature drop across the coil measured
- A heat run with the backup heat called on
- Amp draw on the compressor, fan, blower and heat strip, and static pressure across the air handler
- Thermostat wiring, mode and backup heat settings
- Written findings in order of importance, with the next step for each

## What an inspection can and can't tell you

Readings and a careful look answer a lot. They don't answer everything.

*Questions an inspection can answer, partly answer or not answer*

| Question | Can an inspection answer it? | How |
| --- | --- | --- |
| Is the system running correctly right now? | Yes, for the conditions on the day | Both modes run, with temperatures, amp draws and static pressure measured |
| Is anything about to cause damage? | Often | A full secondary pan, a missing float switch, burned wiring or a cracked drain are visible |
| Is the system the right size for the house? | Partly | Long or short cycles and room complaints are clues; only a load calculation settles it |
| Is the refrigerant charge correct? | Partly | Pressures and temperatures point to it, but readings in mild weather or heat mode are less exact |
| How many years does it have left? | No | Age and condition tell us where it stands; nobody can predict when a part fails |

You get what we measured, what we saw, and an honest line between the two and what we can't yet know.

## How an inspection runs

Five stops, usually in a single visit.

1. Tell us why A house purchase, a system with no records, a storm, a room that never feels right. The reason shapes what we look at hardest.
2. Read and look Nameplates, outdoor unit, line set, air handler, drain and the duct runs we can reach.
3. Run and measure Cooling, then heat with the backup heat, with temperatures, amp draws and static pressure measured.
4. Written findings What we found in order of importance, what it means and what we can't yet tell.
5. Your next step A repair, a maintenance visit, a duct review, a replacement price or nothing at all, priced if you want it.

## Questions we hear about this work

### Should I have a heat pump inspected before buying a house?

It helps when the sale gives you time. A general home inspection usually confirms the system runs; a heat pump inspection measures how it runs, checks the drain and the secondary pan, and reads the nameplates for age and refrigerant. The findings tell you what to budget for in the first year, before you own it.

### Can you inspect a heat pump after a flood or a storm?

Yes, and please do it before switching the system back on if water reached the outdoor unit or the air handler. Heating and cooling equipment isn't designed to withstand flooding, and water in the electrical parts or the controls can be dangerous. We look at how high the water came, the wiring, the controls and the drain before anything runs.

### Can an inspection tell me how long my heat pump will last?

No one can give you an honest number. We can tell you the manufacture date, the condition of the coils, the wiring and the drain, and whether the readings look healthy. That shows where the system stands today and what to watch, but a part can still fail without warning.

### Do you need to get into the attic for an inspection?

If the air handler or the ducts are up there, yes. Many of the problems an inspection finds sit at the air handler, such as a full secondary pan, a missing float switch or loose duct connections. Clear a path to the attic opening and the closet before the visit and the inspection takes less time.

### What happens if the inspection finds a problem?

You get the finding in writing, what it means, and the next step we suggest. Nothing is repaired during the inspection unless you ask for it. If you want the work done, we price each repair on its own, so you can choose what comes first.
